Tryde End Table with Shelf

to build an end table with shelf out of 5- 2x4s!

Tryde End Table with Shelf

Dimensions

Use the size-specific shopping and cut lists below.

Tryde End Table with Shelf dimension diagram 1

What you need

  • 5 - 2x4 @ 8 feet long
  • 2-1/2" pocket hole screws
Work out the boards to buyOpens this cut list in the calculator: board count, where to cut each one, and what is left over.

Step by step

01

Step 1

Place your four longer bottom shelf boards together and measure the overall width of the shelf. This measurement should be close to 14". Cut your shorter aprons to this length. Then drill (2) 1-1/2" pocket holes on each end of each of the apron boards and attach to legs to build the two end leg sets. NOTE: You'll want to also drill 1-1/2" pocket holes (about 2 per apron facing upward, bottom aprons too) for attaching the shelf/tabletop in later steps.

Tryde End Table with Shelf, step 1
02

Step 2

Drill 2 1-1/2" pocket holes per end of each of the longer apron boards and attach to the legs with 2-1/2" pocket hole screws. NOTE: You'll want to also drill 1-1/2" pocket holes (about 2 per apron facing upward, bottom aprons too) for attaching the shelf/tabletop in later steps.

Tryde End Table with Shelf, step 2
03

You may wish to attach the tabletop first for easier access to the underside (see next step).

Build your bottom shelf first with 1-1/2" pocket holes and 2-1/2" pocket hole screws. Then fit inside and attach through the predrilled pocket holes in aprons with 2-1/2" pocket hole screws.

Tryde End Table with Shelf, step 3
04

Step 4

Build tabletop first, then attach completed tabletop to the base through pocket holes on underside, as you did the bottom shelf.

Tryde End Table with Shelf, step 4
05

Finishing

Sand all surfaces, starting with a medium grit and finishing with fine. Wipe off the dust, fill any holes or gaps with wood filler, and sand smooth once dry. Apply primer if you're painting, then finish with your choice of paint or stain and seal with a durable clear topcoat. For outdoor projects, use exterior-rated primer, paint or stain, and sealer so the piece stands up to the weather.